Displaying PM data
...................................................................................................................................................................................................................................
When to use
The following procedures are performed to:
• Display details of any termination point settings
• Display PM and LAN performance data.
Related information
The items below list other relevant information to this procedure:
• Procedure to set the SDH TP Mode, for the required prior setting of the ports to be
monitored. Refer to “Provision ports” (p. 5-59).
• “Concepts” (p. 10-3)
• Parameters used in this procedure can be found at “Parameters for displaying PM
data” (p. 10-52).
Before you begin
The items below gives information on tasks to perform before beginning the procedure:
• A prerequisite for this procedure is to set the port mode to monitored for the TP.
See Related Information below.
• The proper LAN card must be installed in TS2 in order to be able to make
performance LAN measurements.
Viewing TP settings & PM measurements
Follow this procedure in order to view the active measurement point settings of the
NE.
...................................................................................................................................................................................................
1
Select Performance -> PM Current Measurements.
Result: The Performance Monitoring Point Filter window is displayed. The
ITM-CIT is in measurement mode.
...................................................................................................................................................................................................
2
Select a PM Point Type Slot and its Port, and any additional SDH level “Filter”
(p. 10-52) (if applicable). And select
OK to apply the selection.
Result: The Active Performance Monitoring Points window appears.
...................................................................................................................................................................................................
3
Select a Performance Monitoring point from the list of provisioned termination points
and Click
Measurements...
Result: The Performance Monitoring Measurements window appears.
...................................................................................................................................................................................................
4
Select a binning period tab and click Update.
Performance monitoring
...................................................................................................................................................................................................................................
365-312-807R7.2
Issue 4, May 2007
Alcatel-Lucent - Proprietary
See notice on first page
10-49
To Next Page
Loading...
