Provisioning Ethernet services
...................................................................................................................................................................................................................................
When to use
Use this procedure to provision Ethernet services.
Note: The Provisioning Ethernet services procedure is also applicable to X5IP.
Related information
For related information, see:
• “LAN interfaces” (p. 8-30)
• “Ethernet mapping schemes” (p. 8-73)
• “Ethernet over SDH” (p. 8-24)
Before you begin
You must be logged into the ITM CIT and the respective network element.
Required equipment
The following equipment is required to perform this task:
• ITM CIT
Provisioning the basic Ethernet parameters
Proceed as follows to provision the basic Ethernet parameters:
...................................................................................................................................................................................................
1
From the ITM CIT main menu, select Provisioning → Equipment → Prov NE
Components
Result:
The Provisioned NE Components window opens.
...................................................................................................................................................................................................
2
Select the slot where the Ethernet card is located.
Click on
Assign/Unassign.
Result: The Assign NE Units to Slots window appears.
...................................................................................................................................................................................................
3
Depending if the Ethernet card is already inserted in the shelf either select the radio
button
Assign or Auto (for preprovisioning, if no board is inserted in the respective
board).
...................................................................................................................................................................................................
4
To assign a unit, use the pull-down menu for Main Unit and select the correct unit
corresponding to the displayed slot.
Traffic provisioning
...................................................................................................................................................................................................................................
8-98
Alcatel-Lucent - Proprietary
See notice on first page
365-312-807R7.2
Issue 4, May 2007
To Next Page
Loading...
