Alcatel-Lucent 1643 AMS - Page 488

Edit QoS mode
...................................................................................................................................................................................................................................
When to use
To allow the user to manage the configured flow profiles or to use the default flow
profile.
Note: The Edit QoS mode procedure is also applicable to X5IP.
Procedure
Complete the following steps to edit the QoS mode:
...................................................................................................................................................................................................
1
Select Provisioning → LAN Management → Virtual Switch
Result:
The Virtual Switch List window is displayed.
...................................................................................................................................................................................................
2
Select the respective virtual switch and click Details.
Result: The Virtual Switch List Information window appears
...................................................................................................................................................................................................
3
Click Edit and in the Edit Virtaul Switch window select TPID value in the Ether Type
area.
It is recommended only to provide one of the following two values:
•
0x8100
for IEE802.1Q STP
• 0x9100
for IEEE802.1ad STP (provider bridge mode)
...................................................................................................................................................................................................
4
Select the LAN/WAN port in the Port Membership field and click on Port Details.
Result: The Port Information window is displayed.
...................................................................................................................................................................................................
5
Click on Edit.
Result: The Customer/Network Port Information window is displayed.
...................................................................................................................................................................................................
6
In the field QoS Mode select the appropriate mode:
•
Flow Configuration: the Flow Profile definitions in the Virtual Port Descriptor
(QoS Flow Tables) (refer to “Provision QoS Flow Identification Table ” (p. 8-138))
are used for this port.
•
Default Profile: the default profile definitions are used for this port.
Traffic provisioning
...................................................................................................................................................................................................................................
8-136
Alcatel-Lucent - Proprietary
See notice on first page
365-312-807R7.2
Issue 4, May 2007