...................................................................................................................................................................................................
4
Select the ports to be used for the DCC Transparent Cross Connection using the group
boxes
Port A and Port B.
Additional info If a DCC channel is selected, then the combobox is populated with
the not yet connected TPs that support DCC connection, else the box is greyed out.
The ‘not yet connected TP’ means that the DCC of the TP is not enabled and the
TP is not connected by transparent DCC channel.
...................................................................................................................................................................................................
5
Click OK and confirm your changes in the confirmation window.
Result: The newly created DCC Transparent Cross Connection is displayed in the
DCC Transparent Cross Connections window.
E ND OF STEPS
...................................................................................................................................................................................................
Management communication setup
Creating a transparent DCC cross-connection
....................................................................................................................................................................................................................................
365-312-807R7.2
Issue 4, May 2007
Alcatel-Lucent - Proprietary
See notice on first page
4-45
To Next Page
Loading...
