The different values are described in the table below:
Value Description
LAN When the subnetwork type is LAN, the next hop address is
an IP address.
CLNP-Tunnel When the subnetwork type is CLNP-tunnel, the next hop
address is a full NSAP address.
Next hop IP/NSAP
Lists the next hop full NSAP address or IP address.
Important! For IP communication the selector of the NSAP should be 04 instead
of the 01 for OSI.
Owner
Identifies the originator of the routing entry. Possible values are local, manual, or TAP.
The different values are described in the table below:
Value Description
Local A route automatically entered into the table after the node’s
interface is configured with an IP address and a subnet mask.
This route cannot be deleted or manipulated in any way.
Manual Routes entered by the operator. These are the only routes the
operator can manipulate. This value always applies to added
entries.
TAP Routes entered by the TAP provisioning protocol.
Cost
Displays the cost of the route.
TAP advertise
The status of the automatic provisioning protocol. The possible values are enabled or
disabled. The default value is disabled.
TAP learn
The learning status of the automatic provisioning protocol. The possible values are
enabled or disabled. When set to enabled the NE shall process the option field in
incoming LSPs and store the learned routes in the routing table. The default value for
TAP Learn is disabled.
Management communication setup
Parameters for provisioning NE tunnel information
....................................................................................................................................................................................................................................
365-312-807R7.2
Issue 4, May 2007
Alcatel-Lucent - Proprietary
See notice on first page
4-65
To Next Page
Loading...
