Alarm identifier
“Probable cause”
Alarm text Alarm
severity
Reporting
state (default
setting)
P12SNUASgcTHR15
*
P12s Near-end unavailable seconds threshold
crossing 15-min egress
Information Not Reported
P12SNUASgcTHR24
*
P12s Near-end unavailable seconds threshold
crossing 24-hrs egress
Information Not Reported
timing ASAP
The following table lists the default alarm severity assignments of the “timing” ASAP.
Alarm identifier
“Probable cause”
Alarm text Alarm
severity
Reporting state
(default setting)
TBACKcUPM System timing in backup state Informa-
tion
Reported
TLINKcFLR Timing link failed Deferred Reported
TLINKcUNEQ Timing link unequipped Deferred Reported
TSCOcSQ Station clock output squelched Informa-
tion
Reported
sdhPRS ASAP
The following table lists the default alarm severity assignments of the “sdhPRS” ASAP.
Alarm identifier
“Probable cause”
Alarm text Alarm severity Reporting
state (default
setting)
RS1cTIM STM-1 RS trace identifier mismatch Prompt Reported
RS4cTIM STM-4 RS trace identifier mismatch Prompt Reported
STM1cLOF STM-1 Loss of frame alignment Prompt Reported
STM1cLOS STM-1 Loss of input signal Prompt Reported
STM1cNES STM-1 Not expected input signal Information Not Reported
STM4cLOF STM-4 Loss of frame alignment Prompt Reported
STM4cLOS STM-4 Loss of input signal Prompt Reported
STM4cNES STM-4 Not expected input signal Information Not Reported
sdhMS ASAP
The following table lists the default alarm severity assignments of the “ sdhMS” ASAP.
Alarm identifier
“Probable cause”
Alarm text Alarm
severity
Reporting state
(default setting)
MS1cAIS STM-1 MS Alarm indication signal received Information Reported
Alarm management
Alarm Severity Assignment Profile
....................................................................................................................................................................................................................................
6-54
Alcatel-Lucent - Proprietary
See notice on first page
365-312-807R7.2
Issue 4, May 2007
To Next Page
Loading...
