Alarm identifier
“Probable cause”
Alarm text Alarm severity Reporting state
(default setting)
SRUcUMD SHDSL Regenerator Unit unmanageable device
type
Deferred Reported
SRU1cUMD SHDSL Regenerator Unit 1 unmanageable
device type
Deferred Reported
SRU2cUMD SHDSL Regenerator Unit 2 unmanageable
device type
Deferred Reported
SRUcUPF SHDSL Regenerator Unit unprotected failure Prompt Reported
ASAP name
The ASAP name is used to distinguish different ASAPs of the same type.
The following provisioning rules apply to the ASAP name:
1. A user cannot add a new ASAP, using names like “default/Default” (in uppercase
or lowercase).
2. The ASAP name is an alphanumeric string of up to 20 characters.
3. The following characters are permitted in an ASAP name:
• Upper case letters (A { Z),
• Lower case letters (a { z),
• Digits (0 { 9),
• Hyphens (-).
Maximum number of ASAPs
The total number of ASAPs is restricted to 64, including the “DEFAULT” ASAPs, and
independent from the ASAP type, i.e. beyond the overall maximum number of 64,
there is no specific restriction per ASAP type.
Alarm management
Alarm Severity Assignment Profile
....................................................................................................................................................................................................................................
365-312-807R7.2
Issue 4, May 2007
Alcatel-Lucent - Proprietary
See notice on first page
6-61
To Next Page
Loading...
