Alcatel-Lucent 1643 AMS - Page 347

Result: The < XXX> Port Retiming Information window appears.
...................................................................................................................................................................................................
4
Click Edit.
Result: The Edit < XXX> Port Retiming Information window appears.
...................................................................................................................................................................................................
5
Set the Timing Mode. In case of a re-timed value, set also the Fallback Mode and the
Acceptance QL values. (More information on re-timing can be found in the ″Section:
Timing Concepts″.
...................................................................................................................................................................................................
6
Set the Timing Alarm Reporting values.
...................................................................................................................................................................................................
7
Click OK to confirm the current settings.
Result: Depending on the chosen values a warning message can appear. The Edit
<XXX> Port Retiming Information window disappears.
...................................................................................................................................................................................................
8
Click OK.
Result: The < XXX> Port Retiming Information window disappears.
...................................................................................................................................................................................................
9
To set another 1.5 Mbit/s, 2 Mbit/s or X.21 port go to step 2, else go to step 9.
...................................................................................................................................................................................................
10
Click Close.
Result: The Provisioned NE Port Information List window disappears.
Provision STM-N Output Port Timing
To set the parameters for the physical STM-N output ports follow this procedure:
...................................................................................................................................................................................................
1
Select Provisioning --> Transport --> Ports.
Result: The Provisioned NE Port Information List window appears.
...................................................................................................................................................................................................
2
Select an STM-N port from this list and click Timing.
Result: The Port Timing Information window appears.
...................................................................................................................................................................................................
3
Click Edit.
Timing provisioning Provisioning output port timing
....................................................................................................................................................................................................................................
365-312-807R7.2
Issue 4, May 2007
Alcatel-Lucent - Proprietary
See notice on first page
7-45
E ND OF STEPS
...................................................................................................................................................................................................