Remote SHDSL Power Supply (RPS) Support
The 1643 AM/AMS manages an external Remote SHDSL Power Supply (RPS) box via
the MDI/MDO interfaces. Note that remote power supply must be set to ’managed
mode’ by the DIP switch=ON in the power box.
The 1643 AM management system can also be set to ’managed mode’ for the remote
power supply.
The 1643 AM/AMS supports the following remote power supply provisioning
functions.
•
Restart_cmd: Restarts the RPS module after forced shutdown
• Enable/Disable RPS related alarms (per port and not per alarm). This provisioning
is used to suppress alarms generated by the RPS module.
The 1643 AM/AMS remote power supply module supports the following alarms.
• RPS power failure (per box)
• Overl: Overload (per port)
• OpenC: Open circuit (per port)
• FSD: Forced shut down (per port)
• Leak: Leakage asymmetrical (per port)
• HVolt: Overvoltage alarm (per port)
Note that the MDI interfaces 1...4 and MDO interfaces 1...4 will not function as
normal when the RPS is set to managed mode.
Traffic provisioning
SHDSL feature
....................................................................................................................................................................................................................................
8-16
Alcatel-Lucent - Proprietary
See notice on first page
365-312-807R7.2
Issue 4, May 2007
To Next Page
Loading...
