Alcatel-Lucent 1643 AMS - Page 473

Acceptable Frame
Type
x
Ingress Filter x
Mode x
WAN port information details
This table gives an overview of the WAN port information details which, depending on
the Virtual Switch mode, must be provisioned.
Repeater Spanning
Tree
LAN VPN LAN
Interconnect
Port x x x x
Channel x x x x
Ingress Filter x
Acceptable Frame
Type
x
Default User Priority x
PVID x
STP Port State x
STP Port Priority x
STP Port Path Cost x
WAN port capacity
On the 1643 AM or 1643 AMS network element, there are 4 WAN ports totally in a
LAN unit. The mode of the WAN ports 1~4 is given in the table below. Each mode
stands for a type of the capacity combination of the WAN ports. Any other
combination is not allowable currently. Each of the factors Xa, Xb, Xc and Xd can be
range from 1 to 5 respectively
Mode Capacity WAN
port 1
Capacity WAN
port 2
Capacity WAN
port 3
Capacity WAN
port 4
1 100 Mbit/s Xb * 2 Mbit/s Xc * 2 Mbit/s Xd * 2 Mbit/s
2 50 Mbit/s 50 Mbit/s Xc * 2 Mbit/s Xd * 2 Mbit/s
3 50 Mbit/s Xb * 2 Mbit/s Xc * 2 Mbit/s Xd * 2 Mbit/s
4 Xa * 2 Mbit/s 50 Mbit/s Xc * 2 Mbit/s Xd * 2 Mbit/s
Traffic provisioning Parameters for provisioning LAN unit in spanning tree
mode
....................................................................................................................................................................................................................................
365-312-807R7.2
Issue 4, May 2007
Alcatel-Lucent - Proprietary
See notice on first page
8-121