Alcatel-Lucent 1643 AMS - Page 506

Result: The Edit Cross Connection window appears. The From and To fields are
filled in according to the selected cross-connection.
...................................................................................................................................................................................................
4
Change Cross Connection Type from Standard to SNC and select the Slot and the Port
in the protection area. Click
select.
Result: A list of available termination points appears, including the termination
points of the selected cross-connection.
...................................................................................................................................................................................................
5
Select a TP.
Result: The TP appears in the selection box.
...................................................................................................................................................................................................
6
Select OK.
Result: The cross-connection between the selected TPs is made. The Edit Cross
Connection window closes and the modified cross-connection appears in the list of
the Cross Connection List window.
E ND OF STEPS
...................................................................................................................................................................................................
Traffic provisioning Add SNC/N protection to an unprotected cross-connection
....................................................................................................................................................................................................................................
8-154
Alcatel-Lucent - Proprietary
See notice on first page
365-312-807R7.2
Issue 4, May 2007