Selection
Displays the TP address (read only).
Software Version
Displays the software of the NTU device (read only).
TI Mode
When the TI mode is changed to the byte mode, the default value (0x00 or 0x01) will
be shown (editable).
When the TI mode is changed to specific string mode the corresponding API will be
reset to its default value (15 times 0x00 or 15 times 0x01). Auto CRC-7 checkbox will
be unchecked and the CRC-7 will be filled in with the same default value (1 time 0x00
or 1 time 0x01). In case of the 16 times 0x01 default, the API display mode will be set
to Hex.
TIM Detection
When checked the TIM detection is enabled (editable).
Transmitted TSL (Hex, Description)
The SL which is inserted in transmit direction. Hex, Value, and Description (read
only).
Unit ID
Displays the unit identification code of the NTU device (read only).
Vendor Model
Displays the vendor model of the NTU device (read only).
Vendor ID
Displays in the vendor ID of the NTU device (read only).
Traffic provisioning
Parameters for viewing or editing NTU information and
VC 12 termination point information
....................................................................................................................................................................................................................................
8-182
Alcatel-Lucent - Proprietary
See notice on first page
365-312-807R7.2
Issue 4, May 2007
To Next Page
Loading...
