EasyManua.ls Logo

Alcatel-Lucent 1643 AMS - Page 550

Alcatel-Lucent 1643 AMS
724 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Adding MSP protection
...................................................................................................................................................................................................................................
When to use
To set protection on a point-to-point connection. MSP protection should be established
when the transmission plan calls for a protection of a particular point to point
connection.
Related information
Refer to
“Multiplexer Section Protection” (p. 8-21)
Related procedures are:
Slot provisioning.
Port provisioning.
Before you begin
Before adding MSP protection determine the following:
If the physical timing reference of the units to be MSP protected are assigned to a
single logical timing references then these units are no longer available for MSP
protection.
If a port loopback is set on a port, then this port is not available for MSP
protection
Ports have to be in the same AU3-AU4 mode
For 1643 AM or 1643 AMS MSP is already paired. LP1.1 is the working LP2.1 is
the protection.
Do not enable the DCC channel on the protection.
Procedure
...................................................................................................................................................................................................
1
Select Protection -> Transmission -> MSP.
Result: The Provisioned NE MSP Information window is displayed.
...................................................................................................................................................................................................
2
Make a selection and click Add.
Result: The Add MSP window is displayed.
...................................................................................................................................................................................................
3
View the information. To change the information fill in the values with the information
above and click
OK.
Traffic provisioning
...................................................................................................................................................................................................................................
8-198
Alcatel-Lucent - Proprietary
See notice on first page
365-312-807R7.2
Issue 4, May 2007

Table of Contents

Other manuals for Alcatel-Lucent 1643 AMS