Provisioning termination points
...................................................................................................................................................................................................................................
When to use
The termination points enable the user to set or view parameters derived from data
stored in the overhead bytes of the signals. Termination points should be set after
provisioning the transmission path according to the transmission plan.
Related information
If the Trace Identifier Mismatch detection (TIM) is enabled, traffic will be lost when a
mistake in the trace string is made. Upon mismatch Alarm Indication Signal (AIS) is
inserted in the downstream signal and Remote Defect Indicator (RDI) is inserted in the
upstream signal (RDI is only inserted if the directionality is set to bidirectional).
The RS and MS termination points of the STM-1 or STM-4 signals are used to set a
Signal Degraded Value or for Timing Settings. This is described in section
“Provisioning Degraded Signal Threshold”.
Before you begin
The following procedures are related:
• Path Trace Provisioning
• Provision Degraded Signal Thresholds.
Procedure
The purpose of this procedure is to provision termination points. The following
termination point types can be provisioned: AU-4, TU-3, TU-12, VC-4, VC-4-4C,
VC-3, VC-11, VC-12, or RS.
...................................................................................................................................................................................................
1
Select Provisioning -> Transport -> Termination Point.
Result: The Termination Point Filter window appears.
...................................................................................................................................................................................................
2
Select the type of the termination point to be provisioned and fill in its location. Click
OK.
Result: The Termination Point List window appears with a list of termination
points.
...................................................................................................................................................................................................
3
Select the termination point from the list and click Details.
Result: The Provisioned Termination Point Information window appears with
information about the selected termination point.
...................................................................................................................................................................................................
4
Click Edit.
Traffic maintenance
...................................................................................................................................................................................................................................
9-10
Alcatel-Lucent - Proprietary
See notice on first page
365-312-807R7.2
Issue 4, May 2007
To Next Page
Loading...
