...................................................................................................................................................................................................
11
Select the component(s) you wish to be installed. It is recommended to leave the
default setting and install the ITM CIT including the Online Help files.
...................................................................................................................................................................................................
12
Click Next to install the WaveStar
®
ITM-CIT software in the default directory
(C:\..\ITM-CIT).
Important! It is strictly recommended to use the default directory for installing the
ITM CIT software.
When the (current) NE SW is going to be installed the ITM CIT version that fit’s
to the NE version is ’hard coded’ in the installation routine. This means, in case
there’s no according directory available (for example,
C:\..\Lucent Technologies\ITM CIT\<<version identifier>>\Isd\), the
installer will create exactly this directory and puts the extracted “isd” directory
below this directory.
Additional info If for any reason you must install the ITM CIT on a different drive
you can click on the
Browse button to select or create a different directory for the
WaveStar
®
ITM-CIT software.
Additionally you can check the available disk space for all available drives by
clicking on
Disk Space... .Leave the window Available Disk Space by clicking
OK or Cancel.
Activating
Disk Space... may change the default directory to another drive.
...................................................................................................................................................................................................
13
It is optional to define a password. Fill in a password, if required and confirm it.. Then
click
Next.
Result: The Select Program Folder window appears.
...................................................................................................................................................................................................
14
Leave the default setting, select, or create a folder in which the program icons will be
installed. Click
Next.
Result: The WaveStar
®
ITM-CIT is installed. This will take a few minutes. Then
the
Restarting Windows window appears.
...................................................................................................................................................................................................
15
Choose one of the given options and click OK to finish the setup.
Important! It is recommended to reboot the PC before starting up the WaveStar
®
ITM-CIT, but make sure to restart the computer only if other Windows
®
programs
have been closed before.
E ND OF STEPS
...................................................................................................................................................................................................
Getting Started
Install ITM-CIT software
....................................................................................................................................................................................................................................
2-6
Alcatel-Lucent - Proprietary
See notice on first page
365-312-807R7.2
Issue 4, May 2007
To Next Page
Loading...
