Values Description
Manual Switch to working Switch request which
conditionally switches
service to the working TP.
In case a failure is
detected an automatic
switch will take place to
the protection TP. This
switch request only exists
in non-revertive mode.
Manual Switch To Protection Switch request which
conditionally switches
service to the protecting
TP. In case a failure is
detected an automatic
switch will take place to
the working TP.
Forced Switch To Working Switch request which
enforces switching service
to the working TP. It
prevents automatic
switching to the protecting
TP even in case a failure is
detected. This switch
request only exists in
non-revertive mode.
Forced Switch to protection Switch request which
enforces switching service
to the protecting TP. It
prevents automatic
switching to the working
TP (only if the switch
request has a higher
priority than the protection
group state).
Traffic maintenance
Parameters for switching MSP protection
....................................................................................................................................................................................................................................
9-30
Alcatel-Lucent - Proprietary
See notice on first page
365-312-807R7.2
Issue 4, May 2007
To Next Page
Loading...
