Alcatel-Lucent 1643 AMS - Page 649

RTD PM counters, RDT/TCA support, and End-2-End Ethernet
PM - RTD
...................................................................................................................................................................................................................................
When to use
The following procedure is performed when you want to enable the RTD monitor
counters, to set the threshold values and the granularity of the monitored period.
Note: The RTD PM counters, RDT/TCA support, and End-2-End Ethernet PM - RTD
procedure is also applicable to X5IP.
Related information
The items below list other relevant information to this procedure:
• “Ethernet performance monitoring” (p. 10-12)
• Procedure to set the SDH TP Mode, for the required prior setting of the ports to be
monitored. Refer to “Provision ports” (p. 5-59).
• “Concepts” (p. 10-3)
Before you begin
The items below gives information on tasks to perform before beginning the procedure:
• Proper LAN card must be installed in TS2 in order to be able to make performance
LAN measurements.
• A prerequisite for this procedure is to set the virtual switch in spanning tree mode
“Provisioning a virtual switch in spanning tree mode” (p. 8-105).
• “Enable round trip delay measurements” (p. 10-69)
RTD counters
Follow this procedure in order to view the active measurement point settings of the
NE.
...................................................................................................................................................................................................
1
Select Performance → PM TP Configuration.
Result: The Select Performance Monitoring Points window appears in the PM
Configuration mode.
...................................................................................................................................................................................................
2
Select Ethernet Service Route for PM Point Type and enter the Service Route ID and
then click
Add and Ok
Result: The Ethernet Service Route is enabled
...................................................................................................................................................................................................
3
Click Add.
Performance monitoring
...................................................................................................................................................................................................................................
365-312-807R7.2
Issue 4, May 2007
Alcatel-Lucent - Proprietary
See notice on first page
10-67