Alcatel-Lucent 7450 - Page 122

IP Router Configuration Command Reference
122 Router Configuration Guide
IPv6 static routes are not supported on the 7450 ESS except in mixed mode.
Default No static routes are defined.
Parameters ip-prefix/prefix-length — The destination address of the static route.
Values The following values apply to the 7750 SR and 7950 XRS:
Values The following values apply to the 7450 ESS:
ip-address — The IP address of the IP interface. The ip-addr portion of the address command
specifies the IP host address that will be used by the IP interface within the subnet. This
address must be unique within the subnet and specified in dotted decimal notation.
Values The following values apply to the 7750 SR and 7950 XRS:
Values The following value applies to the 7450 ESS:
next-hop
Syntax next-hop {ip-address | ip-int-name | ipv6 address}
Context config>router>static-route-entry
ipv4-prefix a.b.c.d (host bits must be 0)
ipv4-prefix-length 0 to 32
ipv6-prefix x:x:x:x:x:x:x:x (eight 16-bit
pieces)
x:x:x:x:x:x:d.d.d.d
x [0 to FFFF]H
d [0 to 255]D
ipv6-prefix-length 0 to 128
ipv4-prefix a.b.c.d (host bits must be 0)
ipv4-prefix-length 0 to 32
ipv4-address a.b.c.d (host bits must be 0)
ipv6-address x:x:x:x:x:x:x:x[-interface]
x:x:x:x:x:x:d.d.d.d[-interface]
x: [0..FFFF]H
d: [0..255]D
interface: 32 characters maximum, mandatory for link local
addresses
ipv4-address a.b.c.d (host bits must be 0)