Alcatel-Lucent 7450 - Modifying a Filter Policy

Filter Policies
Router Configuration Guide 593
exit
exit
...
----------------------------------------------
A:ALA-7>config>filter#
Modifying a Filter Policy
There are several ways to modify an existing filter policy. A filter policy can be modified
dynamically as part of subscriber management dynamic insertion/removal of filter policy
entries (see the Triple Play Guide for details). A filter policy can be modified indirectly by
configuration change to a match list the filter policy uses (as described earlier in this guide).
In addition, a filter policy can be directly edited as described below.
To access a specific IP (v4/v6), or MAC filter, you must specify the filter ID, or if defined,
filter name. Use the no form of the command to remove the command parameters or return
the parameter to the default setting.
Example: config>filter>ip-filter# description "New IP filter
info"
config>filter>ip-filter# entry 2 create
config>filter>ip-filter>entry$ description "new entry"
config>filter>ip-filter>entry# action drop
config>filter>ip-filter>entry# match dst-ip
10.10.10.104/32
config>filter>ip-filter>entry# exit
config>filter>ip-filter#
The following output displays the modified IP filter output:
A:ALA-7>config>filter# info
----------------------------------------------
...
ip-filter 11 create
description "New IP filter info"
scope exclusive
entry 1 create
match
dst-ip 10.10.10.91/24
src-ip 10.10.10.106/24
exit
action drop
exit
entry 2 create
description "new entry"
match
dst-ip 10.10.10.104/32
exit
action drop