Filter Policies
Router Configuration Guide 581
Configuring Filter Policies with CLI
This section provides information to configure filter policies using the command line
interface.
Topics in this section include:
• Common Configuration Tasks
→ Creating an IPv4 Filter Policy
→ Creating an IPv6 Filter Policy
→ Creating a MAC Filter Policy
→ Creating a Match List for Filter Policies
→ Applying Filter Policies
→ Creating a Redirect Policy
• Filter Management Tasks
→ Renumbering Filter Policy Entries
→ Modifying a Filter Policy
→ Deleting a Filter Policy
→ Modifying a Redirect Policy
→ Deleting a Redirect Policy
→ Copying Filter Policies
Common Configuration Tasks
This section provides a brief overview of the tasks that must be performed for both IP and
MAC filter configurations and provides the CLI commands.
To configure a filter policy, perform the following tasks:
• Creating an IPv4 Filter Policy
• Creating an IPv6 Filter Policy
• Creating a MAC Filter Policy
• Creating a Match List for Filter Policies
• Applying Filter Policies
• Creating a Redirect Policy
To Next Page