Cflowd Configuration Management Tasks
730 Router Configuration Guide
Modifying Global Cflowd Components
Cflowd parameter modifications apply to all instances where cflowd or traffic sampling is
enabled. Changes are applied immediately. Use the following cflowd commands to modify
global cflowd parameters:
CLI Syntax: config>cflowd#
active-timeout minutes
no active-timeout
cache-size num-entries
no cache-size
inactive-timeout seconds
no inactive-timeout
overflow percent
no overflow
rate sample-rate
no rate
[no] shutdown
template-retransmit seconds
no template-retransmit
The following example displays the cflowd command usage to modify configuration
parameters:
Example: config>cflowd# active-timeout 60
config>cflowd# no inactive-timeout
config>cflowd# overflow 2
config>cflowd# rate 10
The following example displays the common cflowd component configuration:
A:ALA-1>config>cflowd# info
#------------------------------------------
active-timeout 60
overflow 2
rate 10
#------------------------------------------
A:ALA-1>config>cflowd#
Modifying Cflowd Collector Parameters
Use the following commands to modify cflowd collector and aggregation parameters:
CLI Syntax: config>cflowd#
collector ip-address[:port] [version version]
no collector ip-address[:port]
To Next Page
Loading...
