VRRP
Router Configuration Guide 403
VRRP Configuration Command Reference
Command Hierarchies
• IPv4 Interface Commands
• Router Interface Commands
• IPv6 Interface Commands
• Priority Control Event Policy Commands
IPv4 Interface Commands
config
— router
— [no] interface interface-name
— vrrp virtual-router-id [owner] *
—no vrrp virtual-router-id
— authentication-key [authentication-key | hash-key] [hash | hash2]
—no authentication-key
— [no] backup ip-address
— [no] bfd-enable service-id interface interface-name dst-ip ip-address
— [no] bfd-enable interface interface-name dst-ip ip-address
— init-delay seconds
—no init-delay
— mac mac-address
—no mac
— [no] master-int-inherit
— message-interval {[seconds] [milliseconds milliseconds]}
—no
message-interval
— [no] ping-reply
— policy policy-id
—no policy
— [no] preempt
— priority priority
—no priority
— [no] ssh-reply
— [no] standby-forwarding
— [no] telnet-reply
— [no] shutdown
— [no] traceroute-reply
VRRP commands are applicable to router interfaces, IES interfaces and VPRN. The
authentication-key, bfd-enable, and ssh-reply commands are applicable only to IPv4
contexts, not IPv6.
To Next Page