Common Configuration Tasks
588 Router Configuration Guide
Apply IP (v4/v6) and MAC Filter Policies to a Service
IP and MAC filter policies are applied by associating them with a SAP and/or spoke-sdp in
ingress and/or egress direction as desired. Filter ID is used to associate an existing filter
policy, or if defined, a Filter Name for that Filter ID policy can be used in the CLI.
The following output displays IP and MAC filters assigned to an ingress and egress SAP and
spoke SDP:
A:ALA-48>config>service>epipe# info
----------------------------------------------
sap 1/1/1.1.1 create
ingress
filter ip 10
exit
egress
filter mac 92
exit
exit
spoke-sdp 8:8 create
ingress
filter ip “epipe sap default filter”
exit
egress
filter mac 91
exit
exit
no shutdown
----------------------------------------------
A:ALA-48>config>service>epipe#
The following output displays an IPv6 filters assigned to an IES service interface:
A:ALA-48>config>service>ies# info
----------------------------------------------
interface "testA" create
address 192.22.1.1/24
sap 2/1/3:0 create
exit
ipv6
ingress
filter ipv6 100
egress
filter ipv6 100
exit
exit
...
----------------------------------------------
A:ALA-48>config>service>ies#
To Next Page
Loading...
