Alcatel-Lucent 7450 - Configuring Cflowd Collectors

Cflowd
Router Configuration Guide 715
The following example displays a common cflowd component configuration:
A:ALA-1>config>cflowd# info
#------------------------------------------
active-timeout 20
inactive-timeout 10
overflow 10
rate 100
#------------------------------------------
A:ALA-1>config>cflowd#
Configuring Cflowd Collectors
To configure cflowd collector parameters, enter the following commands:
CLI Syntax: config>cflowd#
collector ip-address[:port] [version version]
aggregation
as-matrix
destination-prefix
protocol-port
raw
source-destination-prefix
source-prefix
autonomous-system-type [origin | peer]
description description-string
no shutdown
template-set {basic | mpls-ip}
The following example displays a basic cflowd configuration:
A:ALA-1>config>cflowd# info
-----------------------------------------
active-timeout 20
inactive-timeout 10
overflow 10
rate 100
collector 10.10.10.1:2000 version 8
aggregation
as-matrix
raw
exit
description "AS info collector"
exit
collector 10.10.10.2:5000 version 8
aggregation
protocol-port
source-destination-prefix
exit
autonomous-system-type peer
description "Neighbor collector"