VRRP Configuration Command Reference
404 Router Configuration Guide
Router Interface Commands
config
—router [router-name]
— [no] interface ip-int-name
— [no] ipv6
— address ipv6-address/prefix-length [eui-64]
—no address ipv6-address/prefix-length
— icmp6
— packet-too-big [number seconds]
—no packet-too-big
— param-problem [number seconds]
—no param-problem
— redirects [number seconds]
—no redirects
— time-exceeded [number seconds]
—no time-exceeded
— unreachables [number seconds]
—no unreachables
— link-local-address ipv6-address [preferred]
—no
link-local-address
— [no] local-proxy-nd
— neighbor ipv6-address [mac-address]
—no neighbor ipv6-address
— proxy-nd-policy policy-name [policy-name...(up to 5 max)]
—no proxy-nd-policy
IPv6 Interface Commands
The IPv6 interface commands only apply to the 7750 SR and 7950 XRS.
config
—router [router-name]
— [no] interface ip-int-name
— [no] ipv6
— vrrp virtual-router-id [owner]
—no vrrp virtual-router-id
— [no] backup ipv6-address
— [no] bfd-enable service-id interface interface-name dst-ip ip-address
— [no] bfd-enable interface interface-name dst-ip ip-address
— init-delay seconds
—no init-delay
— mac mac-address
—no mac
— [no] master-int-inherit
— message-interval {[seconds] [milliseconds milliseconds]}
—no message-interval
— [no] ping-reply
— policy vrrp-policy-id
—no policy
To Next Page