Filter Configuration Command Reference
564 Router Configuration Guide
prefix-length — Length of the entered IPv4 prefix.
Values 0 to 32
MAC Filter Entry Commands
action
Syntax drop
forward
forward esi esi service-id vpls-service-id
forward sap sap-id
forward sdp sdp-id:vc-id
http-redirect url
rate-limit value
Context config>filter>mac-filter>entry
config>filter>mac-filter>entry>action
Description The action command (under the config>filter>mac-filter context) sets the context for specific action
commands to be performed (under the config>filter>mac-filter>action context) on packets matching
this filter entry.
The following commands are available under the config>filter>mac-filter>entry>action context:
drop – A packet matching the entry will be dropped.
forward – A packet matching the entry will be forwarded using regular routing.
forward esi service-id– A packet matching the entry will be forwarded to an ESI identified first
appliance in Nuage service chain using EVPN-resolved VXLAN tunnel in the specified VPLS service.
forward sap – A packet matching the entry will be forwarded using the configured SAP.
forward sdp – A packet matching the entry will be forwarded using the configured SDP.
http-redirect – Unsupported
rate-limit – Enables ACL rate limiting for packets matching the entry of this ACL filter policy. Rate
limiters are configured by default with MBS = CBS = 10-ms-of-the-rate and high-prio-only = 0.
Default no specific action is configured by default
Parameters esi — Specifies a 10-Byte Ethernet Segment Identifier.
sap-id — Specifies an existing VPLS Ethernet SAP.
sdp-id:vc-id — Specifies an existing red VPLS SDP.
url — Specifies the HTTP web address that will be sent to the user’s browser.
To Next Page
Loading...
