Alcatel-Lucent 7450 - Command Descriptions; Show Commands

Show, Clear, Monitor, and Debug Command Reference
602 Router Configuration Guide
Command Descriptions
• Show Commands
• Clear Commands
• Monitor Commands
• Debug Commands
Show Commands
The following command outputs are examples only; actual displays may differ depending on
supported functionality and user configuration.
dhcp
Syntax dhcp [filter-id]
Context show>filter
Description This command displays DHCP filter information.
Parameters filter-id — Displays detailed information for the specified filter ID and its filter entries.
Values 1 — 65535
Output The following is a sample command output for the command when no filter ID is specified.
Sample Output
*B:TechPubs>config# show filter dhcp
===============================================================================
DHCP Filters
===============================================================================
Filter-Id Applied Description
-------------------------------------------------------------------------------
10 No test-dhcp-filter
-------------------------------------------------------------------------------
Num filter entries: 1
===============================================================================
*B:TechPubs>config#
*B:TechPubs>config# show filter dhcp 10
===============================================================================
DHCP Filter
===============================================================================
Filter-Id : 10 Applied : No
Entries : 0