Common Configuration Tasks
714 Router Configuration Guide
Enabling Cflowd
Cflowd is disabled by default. Executing the command configure cflowd will enable cflowd,
by default cflowd is not shutdown but must be configured including at least one collector to
be active.
Use the following CLI syntax to enable cflowd:
CLI Syntax: config# cflowd
no shutdown
The following example displays the default values when cflowd is initially enabled. No
collectors or collector options are configured.
A:ALA-1>config# info detail
...
#------------------------------------------
echo "Cflowd Configuration"
#------------------------------------------
cflowd
active-timeout 30
cache-size 65536
inactive-timeout 15
overflow 1
rate 1000
template-retransmit 600
no shutdown
exit
#------------------------------------------
A:ALA-1>config#
Configuring Global Cflowd Parameters
The following cflowd parameters apply to all instances where cflowd (traffic sampling) is
enabled.
Use the following CLI commands to configure cflowd parameters:
CLI Syntax: config>cflowd#
active-timeout minutes
cache-size num-entries
inactive-timeout seconds
overflow percent
rate sample-rate
template-retransmit seconds
no shutdown
To Next Page
Loading...
