Alcatel-Lucent 7450 - Router Interface Commands

IP Router Configuration
Router Configuration Guide 93
—no remote-name
— session-limit session-limit
—no session-limit
— [no] shutdown
— next-attempt {same-preference-level | next-preference-level}
—no next-attempt
— replace-result-code code [code...(upto 3 max)]
—no replace-result-code
— peer-address-change-policy {accept | ignore | reject}
— receive-window-size
—no receive-window-size
— [no] shutdown
configure
— router
—l2tp
— tunnel-selection-blacklist
— add-tunnel never
— add-tunnel on reason>[reason...(upto 8 max)]
—no add-tunnel
— add-tunnel
— max-list-length count
—no max-list-length
— max-time minutes
—no max-time
— timeout-action action
—no timeout-action
Router Interface Commands
config
—router [router-name]
— if-attribute
— admin-group group-name value group-value
—no admin-group group-name
— srlg-group group-name value group-value [penalty-weight penalty-weight]
—no srlg-group group-name
— [no] interface ip-int-name gmpls-loopback
— [no] interface ip-int-name [unnumbered-mpls-tp]
— address {ip-address/mask | ip-address netmask} [broadcast all-ones | host-ones]
[track-srrp srrp-instance]
—no address
— [no] allow-directed-broadcasts
— arp-limit limit [log-only] [threshold percent]
—no arp-limit
— arp-timeout seconds
—no arp-timeout
—
bfd transmit-interval [receive receive-interval] [multiplier multiplier] [echo-receive
echo-interval [type cpm-np]
—no bfd
— cflowd-parameters