IP Router Configuration Command Reference
146 Router Configuration Guide
configure>service>vprn>l2tp>tunnel-selection-blacklist
Description This command configured the maximum length of the peer/tunnel blacklist.
This command specifies how many items (tunnels or peers) can be in the tunnel-selection-blacklist. If
a tunnel or peer needs to be added to the tunnel-selection-blacklist and the tunnel-selection-blacklist is
full, the system will remove the item (tunnel or peer) from the blacklist that was in this blacklist for
the longest time.
Default unlimited
Parameters unlimited — Specifies there is no limit.
count — Specifies how many items (tunnels or peers) can be in the tunnel-selection-blacklist.
Values 1 to 65635
max-time
Syntax max-time minutes
no max-time
Context configure>router>l2tp>tunnel-selection-blacklist
configure>service>vprn>l2tp>tunnel-selection-blacklist
Description This command configures time for which an entity (peer or a tunnel) are kept in the blacklist.
Default 5 minutes
Parameters minutes — Specifies the maximum time a tunnel or peer may remain in the blacklist
Values 1 to 60
timeout-action
Syntax timeout-action action
no timeout-action
Context configure>router>l2tp>tunnel-selection-blacklist
configure>service>vprn>l2tp>tunnel-selection-blacklist
Description This command defines an action that will be executed on the entity (peer/tunnel) in the blacklist once
the entity becomes eligible for selection again.
Default remove-from-blacklist
To Next Page
Loading...
