Alcatel-Lucent 7450 - Creating Interface Parameters

VRRP
Router Configuration Guide 397
• master-int-inherit
• priority
• policy
• ping-reply
•preempt
• telnet-reply
• ssh-reply (IPv4 only)
• [no] shutdown
Creating Interface Parameters
If you have multiple subnets configured on an Ethernet interface, you can configure VRRP
on each subnet.
The following displays an IP interface configuration example:
A:SR1>config>router# info
#------------------------------------------
echo "IP Configuration "
#------------------------------------------
interface "system"
address 10.10.0.1/32
exit
interface "testA"
address 123.123.123.123/24
exit
interface "testB"
address 10.10.14.1/24
secondary 10.10.16.1/24
secondary 10.10.17.1/24
secondary 10.10.18.1/24
exit
router-id 10.10.0.1
#------------------------------------------
A:SR1>config>router#
Configuring VRRP Policy Components
The following displays a VRRP policy configuration example:
A:SR1>config>vrrp# info
----------------------------------------------
policy 1
delta-in-use-limit 50