Common Configuration Tasks
726 Router Configuration Guide
Note:
1. Ohe Ethernet (L2-IP) flow template is only supported and exported to IPFIX (v10) collectors
Enabling Cflowd on Interfaces and Filters
This section discusses the following cflowd configuration management tasks:
• Specifying Cflowd Options on an IP Interface
→ Interface Configurations
→ Service Interfaces
• Specifying Sampling Options in Filter Entries
→ Interface Configurations
• Dependencies
Specifying Cflowd Options on an IP Interface
When cflowd is enabled on an interface, all packets forwarded by the interface are subject to
analysis according to the global cflowd configuration and sorted according to the collector
configuration(s).
Refer to Cflowd Configuration Dependencies for configuration combinations.
When the cflowd interface option is configured in the config>router>interface context, the
following requirements must be met to enable traffic sampling on the specific interface:
1. Cflowd must be enabled.
2. At least one cflowd collector must be configured and enabled.
3. The interface>cflowd interface option must be selected. For configuration
information, refer to the Filter Policy Overview section of the Router Configuration
Guide.
ICMP Type Code 32
Table 77: Ethernet (L2-IP) Flow Template (Continued)
Field Name
1
Field ID
To Next Page
Loading...
