Filter Configuration Command Reference
538 Router Configuration Guide
The no form of the command disables sticky destination behavior.
Default no sticky-dest
Parameters hold-time-up — Initial delay in seconds. Zero is equivalent to no-hold-time-up (no delay).
Values 0 to 65535 seconds
IP (v4/v6) Filter Entry Commands
action
Syntax drop
drop packet-length {{lt | eq | gt} packet-length-value | range packet-length-value packet-
length-value}
drop ttl {{lt | eq | gt} ttl-value | range ttl-value ttl-value}
forward
forward esi esi sf-ip ip-address vas-interface interface-name router {router-instance |
service-name service-name}
forward esi esi service-id vpls-service-id
forward lsp lsp-name
forward next-hop [indirect] ip-address
forward next-hop [indirect] ip-address router {router-instance | service-name service-
name}
forward next-hop interface ip-int-name
forward redirect-policy policy-name
forward router {router-instance | service-name service-name}]
forward sap sap-id
forward sdp sdp-id:vc-id
gtp-local-breakout
http-redirect rdr-url-string [allow-radius-override]
nat
[nat-policy nat-policy-name]
rate-limit value
reassemble
tcp-mss-adjust
Context config>filter>ip-filter>entry
config>filter>ip-filter>entry>action
Description This command (under the config>filter>ip-filter context) sets the context for specific action
commands to be performed (under the config>filter>ip-filter>action context) on packets matching
this filter entry.
The following commands are available under the config>filter>ip-filter>entry>action context:
• drop
A packet matching the entry will be dropped.
To Next Page
Loading...
