Show, Clear, Monitor, and Debug Command Reference
644 Router Configuration Guide
Context clear>filter
Description Clears the contents of a memory or file based filter log.
This command has no effect on a syslog based filter log.
Parameters log-id — The filter log ID expressed as a decimal integer.
Values 101 to 199
mac
Syntax mac mac-filter-id [entry entry-id] [ingress | egress]
Context clear>filter
Description Clears the counters associated with the entries of the specified MAC filter policy.
By default, the counters associated with each entry of the specified filter policy are all cleared. The
scope of which counters are cleared can be narrowed using the command line parameters.
Default Clears all counters associated with each entry of the specified MAC filter policy.
Parameters mac-filter-id — The MAC filter policy ID for which to clear the entry counters. Values can either
be expressed as a decimal integer or as an ASCII string of up to 64 characters. The following
values only shows decimal integer.
Values 1 to 65535
entry entry-id — Specifies that only the counters associated with the specified filter policy entry
will be cleared. The values are expressed as a decimal integer.
Values 1 to 65535
ingress — Specifies to only clear the ingress counters.
egress — Specifies to only clear the egress counters.
Monitor Commands
The following command outputs are examples only; actual displays may differ depending on
supported functionality and user configuration.
ip
Syntax ip ip-filter-id entry entry-id [interval seconds] [repeat repeat] [absolute | rate]
Context monitor>filter
To Next Page
Loading...
