Hybrid OpenFlow Switch
Router Configuration Guide 683
Default no-match-action fall-through
Parameters drop — Packets that do not match entries in the flow table as programmed by the OpenFlow
switch will be dropped
fall-through — Packets that do not match entries in the flow table as programmed by the
OpenFlow switch will be forwarded using regular processing by the router. Fall-through
applies if an error occurs that prevents a flow table from being installed in a filter policy.
packet-in — Packets that do not match entries in the flow table as programmed by the OpenFlow
switch will be extracted and sent to the controller in a flow-controlled manner. If this action
is used, an auxiliary channel should be enabled for packet-in processing (using the aux-
channel-enable command).
switch-defined-cookie
Syntax switch-defined-cookie
[no] switch-defined-cookie
Context config>open-flow>of-switch>flowtable
Description This command enables OpenFlow switch-defined Flow Table cookie encoding for flowtable 0 that
allows multi-service operation.
The no form of the command disables the above function.
Default no switch-defined-cookie
Show Commands
The following command outputs are examples only; actual displays may differ depending on
supported functionality and user configuration.
open-flow
Syntax open-flow
Context show
Description Displays OpenFlow switch hybrid information.
of-switch
Syntax of-switch
To Next Page
Loading...
