IP Router Configuration Command Reference
96 Router Configuration Guide
— [no] strip-label
— tcp-mss mss-value
—no tcp-mss
— tos-marking-state {trusted | untrusted}
—no tos-marking-state
— unnumbered [ip-addr | ip-int-name]
—no unnumbered
— [no] urpf-check
— mode {strict | loose | strict-no-ecmp}
—no mode
— vas-if-type {to-from-access | to-from-network | to-from-both}
—no vas-if-type
— [no] mh-primary-interface
— address {ip-address/mask | ip-address netmask}
—no address
— description description-string
—no description
— [no] shutdown
— [no] mh-secondary-interface
— hold-time
holdover-time
—no hold-time
— address {ip-address/mask | ip-address netmask}
—no address
— description description-string
—no description
— [no] shutdown
— route-next-hop-policy
— [no] template template-name
— include-group group-name [pref pref]
—no include-group group-name
— [no] exclude-group group-name
— [no] srlg-enable
— protection-type {link | node}
—no protection-type
— nh-type {ip | tunnel}
—no nh-type
For router interface VRRP commands, see VRRP Configuration Command Reference.
Router Interface IPv6 Commands
config
—router [router-name]
— [no] interface ip-int-name
— [no] ipv6
— address ipv6-address/prefix-length [eui-64]
—no address ipv6-address/prefix-length
— bfd transmit-interval [receive receive-interval] [multiplier multiplier] [echo-
receive echo-interval [type cpm-np]
—no bfd
To Next Page