IP Router Configuration Command Reference
206 Router Configuration Guide
Default no mh-secondary-interface
hold-time
Syntax hold-time holdover-time
no hold-time
Context config>router>mh-secondary-interface
Description The optional hold-time parameter is only applicable for the secondary context and specifies how long
label information learned about the secondary anycast address should be kept after that peer is declared
down. This timer should be set to a value large enough for the remainder of the network to detect the
failure and complete the reconvergence process.
The no form of the command resets the hold-time back to the default value.
Default no hold-time
Parameters holdover-time — Specifies the number of seconds the router should hold label information learned
from the alternate router in its secondary label table. This is to allow the reset of the network
to reconverge after a router failure before the anycast based label assignments are flushed
from the forwarding plane.
Values 0 to 65535
Default 90
Router Interface Filter Commands
egress
Syntax egress
Context config>router>interface
Description This command enables access to the context to configure egress network filter policies for the IP
interface. If an egress filter is not defined, no filtering is performed.
ingress
Syntax ingress
Context config>router>interface
Description This command enables access to the context to configure ingress network filter policies for the IP
interface. If an ingress filter is not defined, no filtering is performed.
To Next Page
Loading...
