VRRP Configuration Command Reference
432 Router Configuration Guide
The POS channel on the port monitored by the VRRP priority
control event. The port-id.channel-id can only be monitored by a
single event in this policy. The channel can be monitored by
multiple VRRP priority control policies. A port and a specific
channel on the port are considered to be separate entities. A port
and a channel on the port can be monitored by separate events in
the same policy.
If the port is provisioned, but the channel does not exist or the port
has not been populated, the appropriate event operational state is
Set – non-populated.
If the port is not provisioned, the event operational state is Set –
non-provisioned.
If the POS interface is configured as a clear-channel, the channel-
id is 1 and the channel bandwidth is the full bandwidth of the port.
Priority Policy LAG Events Commands
lag-port-down
Syntax [no] lag-port-down lag-id
Context config>vrrp>policy>priority-event
Description This command creates the context to configure Link Aggregation Group (LAG) priority control events
that monitor the operational state of the links in the LAG.
The lag-port-down command configures a priority control event. The event monitors the operational
state of each port in the specified LAG. When one or more of the ports enter the operational down state,
the event is considered to be set. When all the ports enter the operational up state, the event is
considered to be clear. As ports enter the operational up state, any previous set threshold that represents
more down ports is considered cleared, while the event is considered to be set.
pxc-id pxc-id.sub-port
pxc keyword
id 1 to 64
sub-port a, b
ccag-id ccag-id. path-id[cc-type]
ccag keyword
id 1 to 8
path-id a, b
cc-type .sap-net, .net-sap
To Next Page
Loading...
