VRRP Configuration Command Reference
426 Router Configuration Guide
Parameters vrrp-policy-id — The VRRP priority control ID expressed as a decimal integer that uniquely
identifies this policy from any other VRRP priority control policy defined on the system. Up
to 1000 policies can be defined.
Values 1 to 9999
context service-id — Specifies the service ID to which this policy applies. A value of zero (0)
means that this policy does not apply to a service but applies to the base router instance.
Values 1 to 2147483647
priority-event
Syntax [no] priority-event
Context config>vrrp>policy vrrp-priority-id
Description This command creates the context to configure VRRP priority control events used to define criteria to
modify the VRRP in-use priority.
A priority control event specifies an object to monitor and the effect on the in-use priority level for an
associated virtual router instance.
Up to 32 priority control events can be configured within the priority-event node.
The no form of the command clears any configured priority events.
Priority Policy Event Commands
hold-clear
Syntax hold-clear seconds
no hold-clear
Context config>vrrp>policy>priority-event>port-down
config>vrrp>policy>priority-event>lag-port-down
config>vrrp>policy>priority-event>route-unknown
Description This command configures the hold clear time for the event. The seconds parameter specifies the hold-
clear time, the amount of time in seconds by which the effect of a cleared event on the associated
virtual router instance is delayed.
The hold-clear time is used to prevent black hole conditions when a virtual router instance advertises
itself as a master before other conditions associated with the cleared event have had a chance to enter
a forwarding state.
Default no hold-clear
To Next Page
Loading...
