Alcatel-Lucent 7450 - Tools Commands

Show, Tools, and Clear Command Reference
752 Router Configuration Guide
Template Retransmit : 60 seconds
Cache Size : 65536 entries
Overflow : 1%
Sample Rate : 1
Active Flows : 34
Total Pkts Rcvd : 801600
Total Pkts Dropped : 0
===============================================================================
Version Info
===============================================================================
Version Status Sent Open Errors
-------------------------------------------------------------------------------
5 Enabled 92 0 0
8 Enabled 46 0 0
9 Enabled 56 1 0
10 Enabled 39 1 0
===============================================================================
Tools Commands
The following command outputs are examples only; actual displays may differ depending on
supported functionality and user configuration.
cache
Syntax cache {all | aggregate {src-dst-proto | src-dst-proto-port}} family {ipv4 | ipv6}
Context tools>dump>cflowd
Description This command displays the contents of the CFLOWD active cache. This information can be displayed
either in raw form where every flow entry is displayed or in an aggregated form.
Table 83 describes the tools dump cflowd cache output fields.
Table 83: Tools Dump Cflowd Cache Output Field Descriptions
Label Description
Proto/Protocol Displays the IPv4 or IPv6 protocol type.
Source Address/Src-IP Displays the source IP address of the flow (IPv4 or IPv6).
Destination Address/
Dst-IP
Displays the destination IP address of the flow (IPv4 or IPv6).
Intf/Ingr Displays the ingress interface associated with the sampled flow (only
displayed with the raw (all) output).