Filter Configuration Command Reference
520 Router Configuration Guide
The no form of the command removes any description string from the context.
Default no description
Parameters description-string — The description character string. Allowed values are any string up to 80
characters long composed of printable, 7-bit ASCII characters. If the string contains special
characters (#, $, spaces, etc.), the entire string must be enclosed within double quotes.
Global Filter Commands
dhcp-filter
Syntax dhcp-filter filter-id [create]
no dhcp-filter filter-id
Context config>filter
Description This command creates a configuration context for the specified DHCP filter policy if it does not exist
and enables the context to configure the specified DHCP filter policy.
Please refer to the Triple Play Service Delivery Architecture Guide for detailed information.
Default No DHCP filter is created by default.
Parameters filter-id — Specifies the DHCP filter policy ID expressed as a decimal integer.
Values 1 to 65535
create — Keyword required to create the configuration context.
dhcp6-filter
Syntax dhcp-filter filter-id [create]
no dhcp-filter filter-id
Context config>filter
Description This command creates a configuration context for the specified DHCP6 filter policy if it does not exist,
and enables the context to configure the specified DHCP filter policy.
Please refer to the Triple Play Service Delivery Architecture Guide for detailed information.
Default No DHCP6 filter is created by default.
Parameters filter-id — Specifies the DHCP6 filter policy ID expressed as a decimal integer.
Values 1 to 65535
To Next Page
Loading...
