Show, Clear, and Debug Command Reference
236 Router Configuration Guide
Command Descriptions
Show Commands
The following command outputs are examples only; actual displays may differ depending on
supported functionality and user configuration.
aggregate
Syntax aggregate [family] [active]
Context show>router
Description This command displays aggregate routes.
Parameters family — Specifies to display IPv4 or IPv6 aggregate routes.
Values ipv4, ipv6
active — When the active keyword is specified, inactive aggregates are filtered out.
Output
Sample Output
*A:CPM133>config>router# show router aggregate
===============================================================================
Aggregates (Router: Base)
===============================================================================
Prefix Aggr IP-Address Aggr AS
Summary AS Set State
NextHop Community NextHopType
-------------------------------------------------------------------------------
10.0.0.0/8 0.0.0.0 0
False False Inactive
100:33 Blackhole
-------------------------------------------------------------------------------
No. of Aggregates: 1
===============================================================================
*A:CPM133>config>router#
arp
Syntax arp [ip-int-name | ip-address/mask | mac ieee-mac-address | summary] [local | dynamic |
static | managed]
Context show>router
To Next Page
Loading...
