Filter Policies
Router Configuration Guide 537
Default no log
Parameters log-id — The filter log ID expressed as a decimal integer.
Values 101 to 199
pbr-down-action-override
Syntax pbr-down-action-override {drop | forward | filter-default-action}
no pbr-down-action-override
Context config>filter>ip-filter>entry
config>filter>ipv6-filter>entry
config>filter>mac-filter>entry
Description This command allows overriding the default action that is applied for entries with PBR/PBF action
defined, when the PBR/PBF target is down.
The no form of the command preserves default behavior when PBR/PBF target is down.
Default no pbr-down-action-override
Parameters drop — Packets matching the entry will be dropped if PBR/PBF target is down.
forward — Packets matching the entry will be forwarded if PBR/PBF target is down.
filter-default-action — Packets matching the entry will be processed as per default-action
configuration for this filter if PBR/PBF target is down.
sticky-dest
Syntax sticky-dest hold-time-up
sticky-dest no-hold-time-up
no sticky-dest
Context config>filter>ip-filter>entry
config>filter>ipv6-filter>entry
config>filter>mac-filter>entry
Description This command configures sticky destination behavior for redundant PBF actions. When enabled, the
secondary PBF target is not changed to a primary PBF target unless the secondary target goes down or
manual switch is forced using activate-primary-action tools command.
The hold-time-up parameter allows the operator to delay programming of the PBF action for a
specified amount of time when PBF is to be activated (transition from both targets down to at least one
target up). When a first PBF target comes up the timer is started and upon the expiry, the primary PBF
target is programmed if it is up. If the primary PBF target is down but the secondary PBF target is UP,
the secondary PBF target is programmed. Otherwise, the PBF action is not activated.
Changing the value of the timer, while the timer is running takes an immediate effect.
To Next Page
Loading...
