IP Router Configuration Command Reference
160 Router Configuration Guide
peer
Syntax peer ip-address
no peer
Context config>router>l2tp>group>tunnel
Description This command configures the peer address.
The no form of the command removes the IP address from the tunnel configuration.
Default no peer
Parameters ip-address — Sets the LNS IP address for the tunnel.
preference
Syntax preference preference
no preference
Context config>router>l2tp>group>tunnel
Description This command configures a preference number that indicates the relative preference assigned to a
tunnel when using a weighted session assignment.
The no form of the command removes the preference value from the tunnel configuration.
Default no preference
Parameters preference — Specifies the tunnel preference number with its group. The value 0 corresponds to
the highest preference.
Values 0 to 16777215
remote-name
Syntax remote-name host-name
no remote-name
Context config>router>l2tp>group>tunnel
Description This command configures a string to be compared to the host name used by the tunnel peer during the
authentication phase of tunnel establishment.
Parameters host-name — Specifies a remote host name for the tunnel up to 64 characters in length.
To Next Page
Loading...
