IP Router Configuration
Router Configuration Guide 199
Parameters group-name — Specifies the name of the group with up to 32 characters. The association of group
name and value should be unique within an IP/MPLS domain.
value group-value — Specifies the integer value associated with the group. The association of
group name and value should be unique within an IP/MPLS domain.
Values 0 to 31
admin-group
Syntax admin-group group-name [group-name...(up to 5 max)]
no admin-group group-name [group-name...(up to 5 max)]
no admin-group
Context config>router>interface>if-attribute
config>service>ies>interface>if-attribute
config>service>vprn>interface>if-attribute
config>router>mpls>interface
Description This command configures the admin group membership of an interface. The user can apply admin
groups to an IES, VPRN, network IP, or MPLS interface.
Each single operation of the admin-group command allows a maximum of five (5) groups to be
specified at a time. However, a maximum of 32 groups can be added to a given interface through
multiple operations. Once an admin group is bound to one or more interface, its value cannot be
changed until all bindings are removed.
The configured admin-group membership will be applied in all levels/areas the interface is
participating in. The same interface cannot have different memberships in different levels/areas.
Only the admin groups bound to an MPLS interface are advertised area-wide in TE link TLVs and sub-
TLVs when the traffic-engineering option is enabled in IS-IS or OSPF. IES and VPRN interfaces do
not have their attributes advertised in TE TLVs.
The no form of this command deletes one or more of the admin-group memberships of an interface.
The user can also delete all memberships of an interface by not specifying a group name.
Parameters group-name — Specifies the name of the group with up to 32 characters. The association of group
name and value should be unique within an IP/MPLS domain.
srlg-group
Syntax srlg-group group-name value group-value [penalty-weight penalty-weight]
no srlg-group group-name
Context config>router>if-attribute
Description This command defines a Shared Risk Link Group (SRLG) which can be associated with an IP or MPLS
interface.
To Next Page
Loading...
