IP Router Configuration Command Reference
142 Router Configuration Guide
exclude-avps
Syntax exclude-avps calling-number
no exclude-avps
Context config>router>l2tp
Description This command configures the L2TP AVPs to exclude.
next-attempt
Syntax next-attempt {same-preference-level | next-preference-level}
no next-attempt
Context configure>router>l2tp
configure>service>vprn>l2tp
Description This command enables tunnel selection algorithm based on the tunnel preference level.
Parameters same-preference-level — In case that the tunnel-spec selection algorithm evaluates into a tunnel
that is currently unavailable (for example tunnel in a blacklist) then the next elected tunnel, if
available, will be chosen within the same preference-level as the last attempted tunnel. Only
when all tunnels within the same preference level are exhausted, the tunnel selection
algorithm will move to the next preference level.
In case that a new session setup request is received while all tunnels on the same preference
level are blacklisted, the L2TP session will try to be established on blacklisted tunnels before
the tunnel selection moves to the next preference level.
ascii-spec char-specification ascii-spec
char-specification ascii-char | char-origin
ascii-char a printable ASCII character
char-origin %origin
origin S | c | r | s | l
S system name, the value of
TIMETRA-CHASSIS-
MIB::tmnxChassisName
c Agent Circuit Id
r Agent Remote Id
s SAP ID, formatted as a character
string
l Logical Line ID
To Next Page
Loading...
