IP Router Configuration Command Reference
144 Router Configuration Guide
Description This command will force the tunnel to the blacklist and render it unavailable for new sessions for the
duration of preconfigured time. Peers are always forced to the black list in case that they time out
(failure to receive response to control packets). In addition to time outs, certain events can be used to
trigger placement of the tunnel on the black list.
Parameters reason — Specifies the return codes or events that determine which tunnels are added to the
blacklist
Table 6: Return codes
Return code Tunnels added to blacklist
cdn-err-code A tunnel will be forced to the blacklist in case that CDN message
with the Result Code 2 (Call disconnected for the reasons indicated
in error code) is received.
cdn-inv-dest A tunnel will be forced to the blacklist in case that CDN message
with the Result Codes 6 (Invalid destination) is received.
cdn-tmp-no-facilities A tunnel will be forced to the blacklist in case that CDN message
with the Result Code 4 is received (Call failed due to lack of
appropriate facilities being available - temporary condition) is
received.
cdn-perm-no-facilities A tunnel will be forced to the blacklist in case that CDN message
with the Result Codes 5 (Call failed due to lack of appropriate
facilities being available - permanent condition) is received.
tx-cdn-not-established-in-
time
A tunnel will be forced to the blacklist in case that CDN message
with the Result Code 10 (Call was not established within time
allotted by LAC) is sent from the LAC to the LNS.
stop-ccn-err-code A tunnel will be forced to the blacklist in case that StopCCN
message with the Result Code 2 (General error – Error Code
indicates the problem) is sent or received.
To Next Page
Loading...
