IP Router Configuration Command Reference
152 Router Configuration Guide
Description This command configures the ISA LNS group.
Parameters lns-group-id — Specifies the LNS group ID.
Values 1 to 4
load-balance-method
Syntax load-balance-method {per-session | per-tunnel}
no load-balance-method
Context config>router>l2tp>group
config>router>l2tp>group>tunnel
Description This command describes how new sessions are assigned to an L2TP ISA MDA.
Parameters per-session — Specifies that the lowest granularity for load-balancing is a session; each session
can be assigned to a different
ISA MDA.
per-tunnel — Specifies that the lowest granularity for load-balancing is a tunnel; all sessions
associated with the same tunnel are assigned to the same ISA MDA; this may be useful or
required in certain cases, for example:
MLPPP with multiple links per bundle;
HPol intermediate destination arbiters where the intermediate destination is an L2TP tunnel.
local-address
Syntax local-address ip-address
no local-address
Context config>router>l2tp>group>tunnel
Description This command configures the local address.
Parameters ip-address — Specifies the IP address used during L2TP authentication.
local-name
Syntax local-name host-name
no local-name
Context config>router>l2tp>group
config>router>l2tp>group>tunnel
Description This command creates the local host name used by this system for the tunnels in this L2TP group
during the authentication phase of tunnel establishment. It can be used to distinguish tunnels.
To Next Page
Loading...
