IP Router Configuration
Router Configuration Guide 173
Description This command configures interface SRLG Group memberships for this interface
local-proxy-arp
Syntax [no] local-proxy-arp
Context config>router>interface
Description This command enables local proxy ARP on the interface.
Default no local-proxy-arp
ip-mtu
Syntax ip-mtu octets
no ip-mtu
Context config>router>if
Description This command configures the IP maximum transmit unit (packet) for the associated router IP interface.
The configured IP-MTU cannot be larger then the calculated IP MTU based on the port MTU
configuration.
The MTU that will be used is:
MINIMUM((Port_MTU - EtherHeaderSize), (Configured ip-mtu))
The no form of the command returns the associated IP interfaces MTU to its default value, which is
calculated, based on the port MTU setting. (For Ethernet ports this will typically be 1554.)
Default no ip-mtu
Parameters octets — Specifies the IP MTU value that should be associated with the IP interface, specified in
octets.
Values 512 to 9000
lag-link-map-profile
Syntax lag-link-map-profile link-map-profile-id
no lag-link-map-profile
Context config>router>if
Description This command assigns a preconfigured lag link map profile to a SAP/network interface configured on
a LAG or a PW port that exists on a LAG. Once assigned/unassigned, the SAP/network interface
egress traffic will be re-hashed over LAG as required by the new configuration.
To Next Page
Loading...
