IP Router Configuration
Router Configuration Guide 191
If the optional destination parameter is specified and the destination address of an incoming IP packet
matches a route with QoS information the packet is classified to the fc and priority associated with that
route, overriding the fc and priority/profile determined from the sap-ingress or network qos policy
associated with the IP interface. If the destination address of the incoming packet matches a route with
no QoS information the fc and priority of the packet remain as determined by the sap-ingress or
network qos policy.
If the optional source parameter is specified and the source address of an incoming IP packet matches
a route with QoS information the packet is classified to the fc and priority associated with that route,
overriding the fc and priority/profile determined from the sap-ingress or network qos policy associated
with the IP interface. If the source address of the incoming packet matches a route with no QoS
information the fc and priority of the packet remain as determined by the sap-ingress or network qos
policy.
If neither the optional source or destination parameter is present, then the default is destination
address matching.
The functionality enabled by the qos-route-lookup command can be applied to IPv4 packets or IPv6
packets on an interface, depending on whether it is present at the interface context (applies to IPv4) or
the interface>ipv6 context (applies to IPv6). The ability to specify source address based QoS lookup
is not supported for IPv6. Subscriber management group interfaces also do not support the source
QPPB option.
The no form of the command reverts to the default.
Default destination
Parameters source — Enables QoS classification of incoming IP packets based on the source address
matching a route with QoS information.
destination — Enables QoS classification of incoming IP packets based on the destination
address matching a route with QoS information.
secure-nd
Syntax [no] secure-nd
Context config>router>if>ipv6
Description This command enables Secure Neighbor Discovery (SeND) on the IPv6 interface.
The no form of the command reverts to the default and disabled SeND.
allow-unsecured-msgs
Syntax [no] allow-unsecured-msgs
Context config>router>if>ipv6>secure-nd
To Next Page
Loading...
